1 Viton o-ring to replace the Crankshaft Position Sensor o-ring.

When removing the CPS, due to the heat of the engine, the old o-ring will be flat and will not seal properly if re-installed. This metric o-ring is sized to properly seal the CPS to the engine.

Durometer Shore: Shore A: 90 Viton SAE Specification: SAE J200

Model Year 94-03 7.3L diesel

Instruction Sheet: No printed instructions included with this item.

Remove the old o-ring and install the new o-ring dry for storage. Prior to CPS installation, coat the o-ring area with fresh motor oil.

 Item #9-001